学术文献库

The recrystallized grain size and texture in alloys can be controlled via the microchemistry state during thermomechanical processing. The influence of concurrent precipitation on recovery and recrystallization is here analyzed by directly correlating (sub)grains of P, CubeND or Cube orientation with second-phase particles in a cold-rolled and non-isothermally annealed Al-Mn alloy. The recrystallized state is dominated by coarse elongated grains with a strong P, weaker CubeND and even weaker Cube texture. The correlated data enables orientation dependent quantification of the density and size of dispersoids on sub-boundaries and subgrains in the deformation zones around large constituent particles. A new modified expression for the Smith-Zener drag from dispersoids on sub-boundaries is derived and used. The results show that the drag on (sub)grain boundaries from dispersoids is orientation dependent, with Cube subgrains experiencing the highest drag after recovery and partial recrystallization. The often observed size advantage of Cube subgrains in Al alloys is not realized due to the increased drag, thereby promoting particle-stimulated nucleation (PSN). Relatively fewer and larger dispersoids in deformation zones around large particles give a reduced Smith-Zener drag on PSN nuclei, thus further strengthening the effect of PSN. Observations substantiating the stronger P texture compared to the CubeND texture are a higher frequency of P subgrains and a faster growth of these subgrains. The applied methodology enables a better understanding of the mechanisms behind the orientation dependent nucleation and growth behavior during recovery and recrystallization with strong concurrent precipitation in Al-Mn alloys. In particular, the methodology gives new insights into the strong P and CubeND textures compared to the Cube texture.