论文标题
使用actosat-czt成像器的镉醇酸酯检测器对离轴偏振的实验验证
Experimental verification of off-axis polarimetry with Cadmium Zinc Telluride detectors of AstroSat-CZT Imager
论文作者
论文摘要
船上Astrosat上的镉悉尿酸成像仪(CZTI)由大量的像素化的CZT检测器组成,能够测量入射硬X射线的极化。在发射之前,对CZTI的极化测量能力进行了实验确认。 CZTI在100-380 keV的能量范围内对螃蟹星云和脉冲星的X射线极化产生了诱人的结果。 CZTI还有助于测量几个伽马射线爆发(GRB)的迅速发射极化。但是,诸如GRB之类的非轴源的极化测量具有挑战性。实验校准对过轴源的CZTI敏感性以增强测量值的敏感性至关重要。在这种情况下,我们报告了通过使用CZTI和实验设置的CZTI和广泛GEANT4模拟的CZT检测器进行的对照实验进行的像素化CZT检测器的离轴偏振能力的验证。我们目前的结果表明,CZT探测器可用于测量左右角度的偏振,直至约60度。但是,在45-60度之间的发病角度,可能需要考虑一些系统效应,这些效应需要考虑到解释测得的极化分数。
The Cadmium Zinc Telluride Imager (CZTI) onboard AstroSat consists of an array of a large number of pixellated CZT detectors capable of measuring the polarization of incident hard X-rays. The polarization measurement capability of CZTI for on-axis sources was experimentally confirmed before the launch. CZTI has yielded tantalizing results on the X-ray polarization of the Crab nebula and pulsar in the energy range of 100 - 380 keV. CZTI has also contributed to the measurement of prompt emission polarization for several Gamma-Ray Bursts (GRBs). However, polarization measurements of off-axis sources like GRBs are challenging. It is vital to experimentally calibrate the CZTI sensitivity to off-axis sources to enhance the credence of the measurements. In this context, we report the verification of the off-axis polarimetric capability of pixellated CZT detectors through the controlled experiments carried out with a CZT detector similar to that used in CZTI and extensive Geant4 simulations of the experimental set-up. Our current results show that the CZT detectors can be used to measure the polarization of bright GRBs up to off-axis angles of ~60 degrees. However, at incidence angles between 45-60 degrees, there might be some systematic effects which needs to be taken into account while interpreting the measured polarisation fraction.