论文标题
来自含有胶束和胶体颗粒的浓缩表面活性剂溶液的液体膜中的涡流
Vortex in liquid films from concentrated surfactant solutions containing micelles and colloidal particles
论文作者
论文摘要
假设:在从具有双峰粒径分布的胶体溶液中蒸发游离液体膜时,可以观察到新的动态现象。这种分布是在阳离子和阴离子表面活性剂的混合(略有浊度)溶液中以自然方式形成的,其中纳米化胶束与微观的沉淀颗粒共存。实验:不蒸发水,膜薄到厚度<100 nm。胶片蒸发后,人们观察到自发的薄膜增厚(300 nm以上)和动态涡流的外观,中间有较薄的薄膜。涡旋壁的逐步剖面具有等于有效的胶束直径(约8 nm)和最多20-30个分层步骤的逐步高度。结果:对于大于100 nm的厚度,到目前为止,从未观察到胶束溶液的泡沫膜中的分层。它证明了蒸发膜中胶束厚的胶体晶体的形成。较大的微肯定颗粒的作用是在高原边界形成过滤蛋糕,该蛋糕支持厚膜。开发的定量机械模型表明,流体动力和表面张力力的平衡稳定了逐步的涡度曲线。不仅在catanionic表面活性剂溶液的膜中观察到涡旋,而且在二氧化硅和乳胶颗粒悬浮液的膜中观察到涡流,后者包含较小的表面活性剂胶束。
Hypothesis: New dynamic phenomena can be observed in evaporating free liquid films from colloidal solutions with bimodal particle size distribution. Such distributions are formed in a natural way in mixed (slightly turbid) solutions of cationic and anionic surfactants, where nanosized micelles coexist with micronsized precipitated particles. Experiment: Without evaporation of water, the films thin down to thickness < 100 nm. Upon water evaporation from the film, one observes spontaneous film thickening (above 300 nm) and appearance of a dynamic vortex with a spot of thinner film in the center. The vortex wall has a stepwise profile with step-height equal to the effective micelle diameter (ca. 8 nm) and up to 20-30 stratification steps. Results: For thicknesses greater than 100 nm, stratification in foam films from micellar solutions has never been observed so far. It evidences for the formation of a thick colloidal crystal of micelles in the evaporating film. The role of the bigger, micronsized particles is to form a filtration cake in the Plateau border, which supports the thick film. The developed quantitative mechanical model shows that the stepwise vortex profile is stabilized by the balance of hydrodynamic and surface tension forces. Vortex is observed not only in films from catanionic surfactant solutions, but also in films from silica and latex particle suspensions, which contain smaller surfactant micelles.