ISO INTERNATIONAL 5415 STANDARD Second edition 2007-12-01 Reduction sleeves with 7/24 external and Morse internal taper and incorporated screw Douilles de rduction aux cies exteur 7/24 et intäeur Morse, avec vis incorporé Reference number ISO 5415:2007(E) @ISO2007 Copyright Intemational Organization for Standardization without license from IHS This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPRIGHTPROTECTEDDOCUMENT ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007 - All rights reserved without ficense from IHS Not for Resale, 12/17/2007 18:32:38 MS7 Foreword IsO (the International Organization for Standardization)is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO5415 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 2, High speed steel cutting tools and their attachments. This second edition cancels and replaces the first edition (isO 5415:1977), which has been technically revised. ii a Licensee=IHS Employ s/111111001,User=Japan, Reduction sleeves with 7/24 external and Morse internal taper andincorporatedscrew Scope This International Standard specifies the dimensions of reduction sleeves with 7/24 external taper No. 30-40-45-50 and 60 and Morse internal taper No. 1 to 6 (Morse taper No. 4, 5 and 6 being either with positive drive, see Figure 2, or without positive drive, see Figure 1). These sleeves permit driving of tools with Morse taper shanks with tapped holes with the aid of an internal screw. The form of this screw and its fixation in the sleeve are left to the manufacturer's discretion. 2 Normativereferences The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso 296, Machine tools Self-holding tapers for tool shanks IsO 297, 7/24 tapers for tool shanks for manual changing IsO 2768-1:1989, General tolerances — Part1:Tolerances for linear and angular dimensions without individual tolerance indications ISO 5413, Machine toolsPositive drive of Morse tapers Dimensions 3.1 General All dimensions and tolerances are given in millimetres. Tolerances not specified shall be of tolerance class “m" in accordance with ISO 2768-1:1989. 3.2Reduction sleeves with7/