ISO INTERNATIONAL STANDARD 2336-1 First edition 1996-04-01 ANSl Internat Doc Sec Hacksaw blades Part 1: Dimensions for hand blades Lamesdesciesdroitesametaux- Partie 1: Dimensions des lames a main so Reference number ISO 2336-1 1996(E) Copyrightlteatinal Organizatin for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 2336-1:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (lsO member bodies). The work of preparing international Standards is normally carried out through isO technicai committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote International Standard iSO 2336-1 was prepared by Technical Committee SO/TC29,Smalltools This first edition of ISO 2336-1 as well as 1SO 2336-2.1996 cancels and replaces 1s0 2336-1980, which has been technically revised. IsO 2336 consists of the following parts, under the general title Hacksaw blades -Part1:Dimensionsforhandblades Part 2.Dimensions formachine blades @ISO1996 All rights reserved Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher International Organization for Standardization racePnetale56.CH-1211Genave20.Swit7arland Copyight International Organizatin for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 2336-1:1996(E) INTERNATIONAL STANDARD ISO Hacksaw blades Part 1: Dimensions for hand blades 1 Scope b) reference to this part of ISO 2336(i.e ISO 2336-1); This part of ISO 2336 specifies the dimensions of hand hacksaw biades c) the blade length, l, in millimetres; It is valid for single edged blades of length equal to d) the width, a, in millimetres; 300 mm, the tooth pitch of which is no greater than 1,4 mm e) the thickness, b, in millimetres; f) the tooth pitch, P, in millimetres, which can be 2 Dimensions supplemented by the number of teeth, N, in 25 mm, given between parentheses. Dimensions shown in figure 1 are given in table 1 with tooth pitch, P, and the number of teeth, N, in EXAMPLE 25 mm. Blade length, l, is the distance between cen- tres of pin holes of diameter d. It is recommended A hand hacksaw blade, of length 1 = 300 mm, of that the centre of the pin hole be located on the width a = 12,5 mm, of thickness b = 0,63 mm and of centreline of the blade. tooth pitch P = 1 mm is designated as follows Designation Saw blade IS0 2336-1 -300 × 12,5 × 0,63 × 1 Hand hacksaw blades, according to this part of or ISO 2336, shall be designated as follows: Saw blade IS0 2336-1 - 300 × 12,5 × 0,63 × 1 a)"Saw blade"; (24) No reproduction or networking permitted without license from IHS Not for Resale